BLADEZ ION 450 Manuel d'instructions télécharger pdf (Page 15)

For use with the following types of systems:

- Ikelite housings for digital cameras with external strobe connector but without TTL

conversion circuitry

- Non-Ikelite housings for digital cameras with Nikonos-style strobe connector

Connect the strobe using an appropriate Ikelite sync cord. The DS160 must be used in

manual exposure modes. Strobe output is not automatically adjusted for proper exposure

when set to TTL(Auto) mode.

USING AS A HARD-WIRED STROBE WITHOUT TTL

For use with the following types of systems:

- Ikelite housings for digital cameras with TTL conversion circuitry

- Ikelite housings for film cameras

- Nikonos V, RS cameras

- Non-Ikelite housings for digital cameras and compatible TTL adapter

Connect the strobe using an appropriate Ikelite TTL sync cord. Digital DSLR cameras

require the use of a Digital TTL sync cord. These cords are designated by a blue band at

one end. The DS160 may be used in TTL(Auto) or manual exposure modes.

TTL (thru-the-lens) exposure automatically compensates for aperture, distance and filters.

Because there's such a wide range of apertures and

subject distances, photographers wanting to easily

balance lighting and control close-up photographer

should select the TTL(Auto) exposure mode. When

the strobe fires, the camera reads the light and signals

the strobe to turn off when the exposure is correct.

Strobe output can be adjusted in TTL(Auto) mode

using either exposure compensation built into the

camera or an exposure compensation module in the

back of the housing (if applicable).

If an exposure compensation module is featured in the

back of the housing, strobe output may be controlled

manually while the strobe itself is left in TTL(Auto)

mode. In order to use the manual exposure modes on

the strobe itself, the housing module must be set in a

manual position.

When using a non-Ikelite TTL adapter or third party

conversion circuitry, please refer to the product's instructions for help in using the DS160

with this setup.

USING AS A TTL HARD-WIRED STROBE

Retaining Ring

Stem O-ring

Blue Band

Ikelite

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Pas de commentaire

BLADEZ ION 450 Manuel d'instructions Page 15