BLADEZ ION 450 Manuel d'instructions télécharger pdf (Page 18)

FUEL GAUGE

When the switch is rotated to the “Batt w/Lite” position, the fuel gauge on the side of the

strobe will display 0, 1, 2, or 3 red LED lights indicating the remaining charge in the

battery pack (see below). When no LED's are illuminated, then the battery capacity is low

and you may have less than 75 full power flashes remaining. For general guidelines,

refer to the following list:

• 3 LED’s - above 75%

• 2 LED’s - above 50%

• 1 LED - above 25%

• No LED - less then 25%

CONFIDENCE SIGNAL

The DS160 strobe features a confidence signal indicator light that will glow if the strobe

receives a TTL quench signal. The #3 LED on the fuel gauge will glow GREEN for three

seconds if the DS160 strobe quenches. This green confidence light illuminates only in the

TTL exposure mode when used with compatible TTL systems.

FIRING MODE SWITCH

Multiple firing modes are featured: TTL/Auto and 9 fractional power settings from the Full

power setting: Full, -1/2, -1, -1 1/2, -2, -2 1/2, -3, -3 1/2, -4, -4 1/2.

TTL(Auto) - Thru-The-Lens/Auto Exposure: The camera automatically signals the strobe

to turn off when the exposure is correct. The camera must feature compatible TTL(Auto)

exposure to utilize this mode on the DS160 when connected directly to the camera. (See

“Using as a Hard-Wired TTL Strobe” section). The TTL(Auto) firing mode MUST be

selected when connecting the optional EV-Controller 4100.6.

Full - Full Power Manual Exposure: The strobe fires at full power each time. You must

select the correct exposure manually. Set the camera aperture based on the subject

distance (see "Exposure Guide" section).

Fractional Power Settings: Select the appropriate power setting to manually balance

the strobe output for available light. Select a fractional power setting

when the strobe-to-subject distance is fixed and the manual full power setting would

over-expose with the camera's selected aperture. The difference between each power

setting is one-half an f-stop; moving from Full power to -1/2 decreases the light output by

one-half an f–stop. Changing the power setting does not alter the coverage angle.

SWITCHES/FUEL GAUGE

(co ntinued )

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

BLADEZ ION 450 Manuel d'instructions Page 18