BLADEZ ION 450 Manuel d'instructions télécharger pdf (Page 4)

INTRODUCTION

Thank you for purchasing an Ikelite Strobe. Ikelite brings over 50 years of underwater

photographic and lighting experience to the strobe market. Ikelite Strobes are designed

and built in the USA by Ikelite to suit both the professional and the amateur photographer.

The purpose of a strobe is to illuminate the subject and assist the camera in taking vivid

pictures. The Ikelite DS160 Strobe is equally suited for general and wide-angle

photography, covering up to a full 100° angle with a diffuser.

The contents of this instruction manual are subject to change at any time without prior

notice.

STARTING OUT

Before using the Ikelite DS160 Strobe, please read this owner’s manual thoroughly and

retain it for future reference. Fully charge your strobe’s battery pack prior to your first use.

Ikelite recommends becoming familiar with the features and functions of the Ikelite DS160

Strobe above water before trying the camera and strobe in the water. And, if you have not

yet done so, it is suggested that you read your camera owner’s manual as well.

STROBE COMPATIBILITY

The DS160 Strobe is compatible with all Ikelite TTL systems and current digital cameras,

as well as all older TTL film cameras including the Nikonos system. A variety of sync

cords, sensors, and TTL adapters are available to connect to almost any camera system

currently on the market.

STROBE POWER

The DS160 recycles in a quick 1.4 sec from full discharge. When fired at a fractional

power — whether in TTL or manual mode — the strobe recycles virtually instantaneously.

Number of flashes per full charge will increase dramatically in most cases when using in

TTL mode with a compatible camera system. The powerful DS160 is adjustable in 10

half-stop increments for precise control over your exposure when used in manual mode.

IKELITE DS160 STROBE

(continued)

1 2 3 4 5 6 7 8 9 ... 23 24

Pas de commentaire

BLADEZ ION 450 Manuel d'instructions Page 4